The WOOD-STOCK Thermo-compression Technology incorporates to integrates in an eco-friendly single processing cycle a variety of functions by inserting Reinforcing Elements, Soft Cushions, Pivating Pins & Various Cover materials such as Fabric / PVC / TPO and inserts Duly Trimmed and finished with a cycle time as low as 100 sec. and with a two cavity mould a capacity of one semi automatic lines goes up to 3,00,000 Components / years. With only three - four person per shift. Bed size of the press is 1,88 x 2,500 mm. which enables manufacturing of components of large size or operate with Twin Cavity Moulds.

WOOD-STOCK sheets are extruded in a sheet form from a mix of Thermoformable Polypropylene and Wood Flour. Recycleable property of WOOD-STOCK enables no wastage in process.

Accepted the World over, this technology is used to manufacture Rear Parcel Shelves, Door Triims, Head Liners, Seat Backs, Trunk Liners and Sun Visors by almost all automobile manufacturers.

	Process produced very economical and Luxurious Door Trims.
	Used in Cars like Alfa Romeo, BMW, Chysler, Daewoo, Ford Fiat, Huyandi, Honda, Lancis, Maruti, Marcedes, Nissan, Opel Renault, Rover, Skoda, Toyota, Volkswagen, Volvo etc.
	Forming of the Panel Switch by two or three coverings (PVC and Fabrics) in different colors press stocks.
	Door panels, Ornaments, Arm Rests, Piller Covering etc. moulded in one press stroke with PVC / TPO / Fibres.
	Moulded Panels with double blow-moulded sheets in a single stroke.
	High structural stiffness with very strong build in pocket.
	Edge folding on the peripheral.
	Very deep shapes with high degree of finish and comfort.
	Various options...
	The whole trim Just the insert Fabric Ornament Only Garnish Moulded with Board Assembly.