The Wind Mills parts are based on FRP by Contact Moulding Process, using special types of Glass Reinforcement and Polyster Resins.

The parts being produced are supplied for 1.5 MW Windmills. These parts are characterized by : -

Very low weight to strength ratio.

Ultraviolet Stabalization.

Exellent Anticorrosive properties suitable for use near coastal and in high   salinity areas.

The parts are large in size

Nacelle cover is as big as..
  8.7 mts. x 3.55 mts. x 3.60 mts.
  These are made in two halves.

Nose Cone is as big as..
  Dia. - 3.2 mts.
  Height - 3.2 mts.
  These are made in three equal parts.